QuickStats:

  • Height: 43mm (exclude thread)
  • Diameter: 22mm
  • Capacity of tank: 3.0ml
  • 2-Post design w/ 2 holes per post
  • 1 x Replacement glass tube
  • 1 x Big hole drip tip
  • 1 x Replacement ceramic baffle
  • 1 x spare parts polybag

Overview
Another budget buster here folks. This is the Avocado tank. Expect it to be a tank that isn’t quite everything you want, but pretty close to it. It’s super easy to build with the 2 post system having two individual holes per post. This means that there is no more fitting both wires from a dual coil in the same post and having to tighten them down together. The tank offers single coil mode and dual coil mode. The Avocado has multiple airflow configuration options so that you are sure to find your desired airflow with no problems. The 3ml capacity is just enough to not feel like you have to constantly fill the tank without having to have a huge device to look at on top of your mod. The two options of drip tips that are offered was a nice touch. The Avocado has the potential to be a ‘cloud chasing tank’ as well as a flavor chasing tank. The flavor can be had in single coil mode by putting in the ceramic plug on one side and closing off the airflow. I will say that in both modes and at the appropriate wattage for the coil/coils I was using the flavor seemed to be what I was used to in other atomizers.
As with almost any device on the market there are some miniscule problems that you may encounter when you are using this tank. The filling method in dual coil mode can be a little tedious if you need to refill on the go. Since there is no dedicated fill hole, your cotton takes up the only available holes and you must find a way to get your juice into the tank with the cotton in the way. This is not a big problem if you build with something like a 2.5mm screwdriver or smaller. The wick holes are 4mm but when you put 3mm of cotton in there and it gets saturated with juice, they easily expand to fill the available area and leave you with no room to fill.

Avocado-2

Should you buy it?
If you are looking for a tank that doesn’t cost a lot and is easy to build then you might want to try and pick one up. I will advise you to wait for a bit until the Avocado 24mm is available since it comes with a dedicated fill hole. The only issue is definitely the filling. Other than that it seems to be a super solid affordable tank. Other tanks that are similar in performance would be the Aromamizer, the Griffin, and maybe the moonshot. This is however, super easy to build with high adjustment possibilities. I would say it’s a good buy.

Avocado-1